Hi all,
I am extremely new to Juniper. Please bear with me.
Reading virtual chassis feature guide on configuring virtual chassis
In pre-provisioned
- mastership priority cannot be defined but will be set to the same for master and backup RE
- role is pre-defined to the serial number of switch
- memberid is pre-defined to the serial number of switch
- switch intended to be master is powered on
In non-provisioned
- mastership priority can be defined but will be set to the same for master and backup RE
- switch intended to be master is powered on
============================
So the only difference between a pre-provisioned and non-provisioned is that
- in pre-provisioned, you can define/tied the intended role to the desired switch ?
- in pre-provisioned, you can define the memberID to the desired switch ? ?
Q1) What other benefits/non-benefits does 1 have over the other ? Why would one choose pre-provisioned over non-provisioned ?
In a 2 members virtual chassis, how will the above matters ?
Q2) When specifying an interface in a virtual-chassis setup, what is the relationship between FPC and memberID ?
Say FPC2 (switch2) is define with a memberID of 6, when we want to refer to port1 of switch2 , do we specify
ge-6/0/1 or ge-2/0/1 in a virtual chassis ?
I am using 2 x qfx5100-48s-6q
Regards,
Alan