Hi All,
Some times FXPC on ex4600 is getting very high level like (80% or 90%). How to investigate which thing is causing this. And what is the solution? Any one experience this. And also there is a interrupt 2%. Can I ask what is this and how to troubleshooting?
>show system processes extensive | except 0.00
last pid: 86889; load averages: 0.45, 0.50, 0.48 up 217+00:57:54 11:04:23
146 processes: 4 running, 124 sleeping, 18 waiting
Mem: 473M Active, 175M Inact, 484M Wired, 729M Cache, 69M Buf, 25M Free
Swap: 614M Total, 614M Free
PID USERNAME THR PRI NICE SIZE RES STATE TIME WCPU COMMAND
10 root 1 171 52 0K 12K RUN 2980.0 73.54% idle
1708 root 2 44 -52 1190M 444M select 1134.5 17.68% fxpc <--------
1891 root 1 96 0 67304K 23772K select 779.2H 1.03% jdhcpd
13 root 1 -40 -159 0K 12K WAIT 71.7H 0.83% swi2: netisr 0
1916 root 1 96 0 33576K 22028K select 621:43 0.15% l2ald
1699 root 1 96 0 52136K 18508K select 38.6H 0.10% chassisd
>show chassis routing-engine
Routing Engine status:
Slot 0:
Current state Master
Temperature 40 degrees C / 104 degrees F
CPU temperature 40 degrees C / 104 degrees F
DRAM 1953 MB
Memory utilization 52 percent
CPU utilization:
User 13 percent
Background 0 percent
Kernel 12 percent
Interrupt 2 percent <------------------
Idle 74 percent
Model EX4600
Serial ID BUILTIN
Start time 2018-10-26 11:06:59 EST
Uptime 117 days, 54 minutes, 55 seconds
Last reboot reason 0x1
ower cycle/failure
Load averages: 1 minute 5 minute 15 minute
0.69 0.52 0.48
Thx
Ar