Hi, i've got a virtual chassis configured, but i don't see to be able to see the ports of the Backup Switch in order to configure them. Are they configured separately through the backup switch management port?
# run show virtual-chassis
Preprovisioned Virtual Chassis
Virtual Chassis ID: 18fe.c820.caf0
Virtual Chassis Mode: Enabled
Mstr Mixed Route Neighbor List
Member ID Status Serial No Model prio Role Mode Mode ID Interface
0 (FPC 0) Prsnt TC37182XXXX ex4600-40f 129 Master* N VC 1 vcp-255/0/0
1 vcp-255/0/1
1 (FPC 1) Prsnt TC37182XXXX ex4600-40f 129 Backup N VC 0 vcp-255/0/0
0 vcp-255/0/1
{master:0}[edit interfaces]
# edit ?
Possible completions:
<interface-name> Interface name
em0 Interface name
em1 Interface name
et-0/0/24 Interface name
et-0/0/25 Interface name
et-0/0/26 Interface name
et-0/0/27 Interface name
> interface-range Interface ranges configuration
> interface-set Logical interface set configuration
irb Interface name
> traceoptions Interface trace options
vme Interface name
xe-0/0/0 Interface name
xe-0/0/1 Interface name
xe-0/0/10 Interface name
xe-0/0/11 Interface name
xe-0/0/12 Interface name
xe-0/0/13 Interface name
xe-0/0/14 Interface name
xe-0/0/15 Interface name
xe-0/0/16 Interface name
xe-0/0/17 Interface name
xe-0/0/18 Interface name
xe-0/0/19 Interface name
xe-0/0/2 Interface name
xe-0/0/20 Interface name
xe-0/0/21 Interface name
xe-0/0/22 Interface name
xe-0/0/23 Interface name
xe-0/0/24:0 Interface name
xe-0/0/24:1 Interface name
xe-0/0/24:2 Interface name
xe-0/0/24:3 Interface name
xe-0/0/25:0 Interface name
xe-0/0/25:1 Interface name
xe-0/0/25:2 Interface name
xe-0/0/25:3 Interface name
xe-0/0/26:0 Interface name
xe-0/0/26:1 Interface name
xe-0/0/26:2 Interface name
xe-0/0/26:3 Interface name
xe-0/0/27:0 Interface name
xe-0/0/27:1 Interface name
xe-0/0/27:2 Interface name
xe-0/0/27:3 Interface name
xe-0/0/3 Interface name
xe-0/0/4 Interface name
xe-0/0/5 Interface name
xe-0/0/6 Interface name
xe-0/0/7 Interface name
xe-0/0/8 Interface name
xe-0/0/9 Interface name
{master:0}[edit interfaces]
How can i configure the ports of the backup switch?