Hi all,
When looking at the mx,srx,qfx and others, there is no any holding routes on pfe table when using the cli of ">show route forwarding-table | match hold"
But when doing this on ex9200, all the time of executing the cli of ">show route forwarding-table | match hold" shows a lot of routes with different irb interfaces in the output...
When looking at the juniper resources, it says:
.......hold—Next hop is waiting to be resolved into a unicast or multicast type.
9200ex>show route forwarding-table | match hold
10.100.13.12/32 dest 0 10.100.13.12 hold 1501 1 irb.35
10.100.13.13/32 dest 0 10.100.13.13 hold 1333 1 irb.35
10.100.35.11/32 dest 0 10.100.35.11 hold 1731 1 irb.125
10.100.120.100/32 dest 0 10.100.120.100 hold 1629 1 irb.230
10.100.120.120/32 dest 0 10.100.120.120 hold 1557 1 irb.230
10.100.120.115/32 dest 0 10.100.120.115 hold 1247 1 irb.230
10.100.132.11/32 dest 0 10.100.132.11 hold 529 1 irb.230
10.100.132.33/32 dest 0 10.100.132.33 hold 1373 1 irb.230
10.100.132.47/32 dest 0 10.100.132.47 hold 1438 1 irb.230
10.100.132.38/32 dest 0 10.100.132.38 hold 1702 1 irb.230
10.100.132.22/32 dest 0 10.100.132.22 hold 1484 1 irb.230
10.100.132.78/32 dest 0 10.100.132.78 hold 1783 1 irb.230
10.100.133.53/32 dest 0 10.100.133.53 hold 1605 1 irb.130
10.100.133.64/32 dest 0 10.100.133.64 hold 1839 1 irb.130
10.100.150.31/32 dest 0 10.100.150.31 hold 1851 1 irb.141
10.100.127.79/32 dest 0 10.100.127.79 hold 1755 1 irb.137
10.100.127.66/32 dest 0 10.100.127.66 hold 1782 1 irb.137
10.100.145.47/32 dest 0 10.100.145.47 hold 1844 1 irb.138
Can I ask about what reason could be > and secondly where to start troublehooting?
Thx
A.