Hi,
Just need some clarity on the ex2200-C POE switch.Currently i have a few access points (4) connected to it. There is also a outdoor access point that need to be powered but it requires more power than than the indoor ones. According to datasheet all ports can provide a max of 30W depeneding on what is configured where.So the interface in question is ge-0/0/1. It seems like the endpoint AP only draws 9.8W and goes into a bootup loop, not sure if it due to not enough power being provided to the AP etc. Can anyone shared their expereice on this.Perhaps some specific configuration.
root@as-4> show configuration poe
management class;
interface all;
root@as-4> show poe interface
Interface Admin Oper Max Priority Power Class
status status power consumption
ge-0/0/0 Enabled ON 30.0W Low 10.0W 4
ge-0/0/1 Enabled ON 25.0W(L) Low 9.8W 4
