Experts,
My configuration for aerohive access point is:
show configuration interfaces ge-0/0/20
unit 0 {
family ethernet-switching {
port-mode trunk;
vlan {
members [ all ];
}
native-vlan-id 100;
}
}
Aerohive controller is 192.168.100.2 = v100
If I delete native vlan 100 aerohive access point does not to want to connect. The reson is I have noticed all trunk ports where aerohive access points are connected are bouncing back up and down from time to time. So I believe STP kicks in and casue the loop, also other ports - access ports where computers and phones (voice) are connected sporadically boucning up/down. I believe the ports should not bounce up/down at all, at least we did not see anything like that with cisco switches. So I believe Juniper
Does anybody has a config for aerohive that does not uses native vlan 100? Or any other advices?
Thank you