Hi everyone,
I am researching some Uplink module features on EX 4200.
SFP+ uplink module
Supports two 10 GIG ( port 0, port 2) or either 4 one gig ports.
Default is 10GIG
1)My question is how would all four ports appear by default if I do show interface terse?
will they appear as:
xe-0/1/0 ( because by default port 0 is 10G as per link)
xe-0/1/2 ( because by default por 1 is 10 G as per link)
ge-0/1/3
ge-0/1/1
2)If we change the default behavior by using :
user@switch# set chassis fpc 0 pic 1 sfpplus pic-mode 1g
How would ports will appear when we run show interface terse now?
3) Can we use any above ports on the module for Virtual chassis connection?
4) Can we use any port on PIC 0 for Virtual chassis?
Thanks and have a nice day!!