EX2300 PoE port

So, I am using the CLI to disable and then trying to re-enable the PoE on a port. Do I have the enable command wrong, because it does not change to ENABLE.

{master:0}[edit]
admin@001# run show poe interface ge-0/0/33
PoE interface status:
PoE interface                : ge-0/0/33
Administrative status        : Disabled
Operational status           : Disabled
Power limit on the interface : 0.0W
Priority                     : Low
Power consumed               : 0.0W
Class of power device        : not-applicable
PoE Mode                     :   802.3at


{master:0}[edit]
admin@001# set poe interface ge-0/0/33

{master:0}[edit]
admin@001# commit
configuration check succeeds
commit complete

{master:0}[edit]
admin@001# run show poe interface ge-0/0/33
PoE interface status:
PoE interface                : ge-0/0/33
Administrative status        : Disabled
Operational status           : Disabled
Power limit on the interface : 0.0W
Priority                     : High
Power consumed               : 0.0W
Class of power device        : not-applicable
PoE Mode                     :   802.3at

{master:0}[edit]
admin@001# exit
Exiting configuration mode

{master:0}
admin@001> show poe interface ge-0/0/33
PoE interface status:
PoE interface                : ge-0/0/33
Administrative status        : Enabled
Operational status           :  OFF
Power limit on the interface : 0.0W
Priority                     : High
Power consumed               : 0.0W
Class of power device        : not-applicable
PoE Mode                     :   802.3at

{master:0}
admin@001>

The command I used was:

set poe interface ge-0/0/33