Hello. Our organization is migrating from Cisco to Juniper. We dont have much time to assimilate to the new syntax so I wanted to reach out to the Juniper Community to see if someone had time to assist with translation. I have been reading the support forums and installation guides and command guides but I find I am spending to much time reading instead of getting down to the meat and potatoes. Any assistance would be appreciated. Some of the syntax might repeat.
*******Interface Commands*******
interface giX/X/X
description XXXX
switchport mode access
switchport access vlan XXX
switchport voice vlan XXX
authentication control-direction in
authentication event server dead action authorize voice
authentication event fail action next-method
authentication host-mode multi-domain
mab
authentication order dot1x mab
authentication priority dot1x mab
authentication port-control auto
authentication periodic
authentication violation restrict
authentication timer reauthenticate 3599
dot1x pae authenticator
dot1x timeout quiet-period 5
dot1x timeout server-timeout 90
dot1x timeout tx-period 15
spanning-tree bpduguard enable
spanning-tree portfast
spanning-tree portfast edge
no snmp trap link-status
storm-control broadcast level 1.00
storm-control multicast level 1.00
no shutdown
******QNQ****** (Stays the Same - Ensure Router side has MTU 9000 as well)
vlan dot1q tag native (GLOBAL COMMAND)
system mtu jumbo 9100 (GLOBAL COMMAND)
default interface GiX/X/X
interface GiX/X/X
description QnQ
switchport mode access
switchport host
switchport access vlan XXXX
switchport mode dot1q-tunnel
l2protocol-tunnel cdp
l2protocol-tunnel lldp
l2protocol-tunnel stp
l2protocol-tunnel vtp
storm-control broadcast level 1.00
storm-control multicast level 1.00
no shut
end
default interface X/X/X
interface X/X/X
switchport trunk allowed vlan XXX,XXX,XXXX,XXXX,XXX,XXX (Specific VLANS)
switchport trunk allowed vlan X-XXXX,XXXX-XXXX (Range of VLANS)
switchport trunk encap dot1q
switchport mode trunk
switchport trunk native vlan XXXX
switchport nonegotiate
spanning-tree mst 0-2,15 cost 17500
*****Additional Interface Commands*****
authentication event fail action authorize vlan XXX
authentication host-mode multi-host
spanning-tree bpdufilter enable
mls qos vlan-based
ip device tracking maximum 0
authentication open
power inline auto max 15400
speed 100
duplex full